MLAN Command Introduction History

The table below documents when MLAN commands have been added to the MLAN software. The chip version number can be found on the MLAN chip within the controller.

In most cases with the introduction of new commands to the software in MLAN chips, 12 software chips were either first to be updated or both the 12 software and the 4 software chips were updated at the same time. Not all chips are listed below. What is listed are chips that marked a change in the software and were available for testing. If your chip is not listed, it may indicate that your chip did not mark a change in the software or possibly it was available for testing when this data was compiled. Chips versions numbers indicate a date. For instance chip "60603A" means 1996 (6), June (06), 3rd (03) followed by "T" for twelve software or "A" for four software. Your chip version number may fall somewhere in between the chips listed below if it is not directly listed.

Other Notes:
  • Controllers using chips prior to 60603A (06/03/1996) have an earlier circuit board which would need replacement if the chip is to be updated.
  • Chips after 90317A (03/17/1999) will have all parameters available.
MLAN Command Chip Version (printed on Chip)
GET VERSION60603A (06/03/1996)
CLEAR TOTALS20414A (04/14/1992) or before
CLEAR TOTALS IMM80609A (06/09/1998)
GET ADDRESS50925 (09/25/1995)
GET ALL PARAMETERS60809A (08/09/1996)
Note: This command was not present in several chip versions released during the years 1999, 2000 , 2001 and early 2002.
GET BATCH INFO60603A (06/03/1996)
GET CWT30913A (09/13/1993)
GET DISPLAY50925 (09/25/1995)
GET PARAMETER70205T (02/05/1997)
GET SETTINGS 20414A (04/14/1992) or before
GET STATUS41019A (10/19/1994)
GET STEADY STATE RATE60603A (06/03/1996)
GET TARGET THRUPUT STATUS90317A (03/17/1999)
GET TOTALS20414A (04/14/1992) or before
GET TYPE20414A (04/14/1992) or before
GET WEIGHT UNITS60710T (07/10/1996)
SET REMOTE KEYPAD60911T (09/11/1996)
SEND KEYSTROKE60911T (09/11/1996)
SEND SETTINGS20414A (04/14/1992) or before
SET BATCH WEIGHT60603A (06/03/1996)
SET DATE TIME60603A (06/03/1996)
SET PARAMETER70529A (05/29/1997)
SET STEADY STATE RATE70916T (09/16/1997)
SET TAG60710T (07/10/1996)
SET TARGET THROUGHPUT90317A (03/17/1999)
SET WEIGHT UNITS60710T (07/10/1996)
SILENCE ALARM60603A (06/03/1996)
START/STOP/STATUS60603A (06/03/1996)
STOP CYCLE STOP RETRY71222T (12/22/1997)
4COMP or 12 COMP XT PARAMETERS60603A (06/03/1996)